Small Witch Set
Prosthetic Appliance only.
Although most of the appliances can be worn in several places, it is best to check for proper alignment of some pieces. Brush Spirit Gum on the back of the WoochieŽ appliance anywhere it the will be touching the skin. Spirit Gum may also be applied directly to the skin, especially on larger pieces. Position the WoochieŽ appliance onto the skin in the desired area and press into place. Edges may be trimmed for a better fit. For best adhesion, remove the WoochieŽ appliance and use the appliance itself (or your index finger) to tack the Spirit Gum with a rapid up and down motion. This will cause the Spirit Gum to become extremely tacky. Then firmly press the appliance back into place. Using a cotton swab or brush, apply congealed blood or wound filler to any area you desire to have a thick gooey look. For a more realistic look you can add a runny Blood, to give you a freshly bleeding look.
Optional Suggestions for a more professional look
For thinner edges, after applying the WoochieŽ appliance to your skin with Spirit Gum, the edges of the WoochieŽ appliance may be stippled, using a small piece of White Latex Sponge, with a thin coat of liquid Latex. Allow this to dry before applying a second coat. A hair dryer set on low will help speed up the drying time. Powder the dried latex when finished.
To add bruises and trauma after the application of the WoochieŽ appliance, use a grease-based make-up and a small piece of Black Stipple Sponge to stipple, using an up and down motion, a small amount of colours such as yellow, red and purple. Apply the makeup from the lightest to darkest colors, starting with the yellow in the center of the bruised area and following with the red and purple around the outside edges. Using a piece of white latex sponge blend the colors outward from the center. Powder with a colourless powder to help prevent the makeup from rubbing off easily. Dust off excess powder with damp towel or tissue.
Before removing the WoochieŽ appliance, the excess blood should be wiped off using a paper towel and warm water. Using a small brush or cotton swab work a small amount of adhesive remover under the edges of the WoochieŽ appliance. Be careful when working around the eyes, to not get any remover or blood in the eyes. Once removed, remove any residual adhesive or makeup by rubbing more remover into the area. Rinse the skin using a towel and warm water. For additional applications, clean the WoochieŽ appliance with soap and water and a small amount of alcohol. Let dry and store out of the damaging rays of direct sunlight.